How to install webcam ?

　　The installation of the network camera is no longer as cumbersome as the traditional hard disk video recorder. Users can basically operate it according to the instructions. Some network cameras are equipped with solar energy charging. The installation may be relatively cumbersome for users, but the basic method are almost the same.

　　webcam

　　To install a webcam you can do this:

　　1. Prepare to install the supporting parts of the network camera, pliers, screwdriver, network camera, network camera power cable, network camera bracket, chassis, two BNC connectors, and connect the BNC cable.

　　2. Pick up the webcam bracket and install the chassis on the bracket.

　　3. Install the webcam on the bracket.

　　4. Check whether the webcam power supply is the supporting power supply of the webcam.

　　5. Connect the power plug and webcam plug.

　　6. Take out the BNC wire and cut out the middle copper wire from a small section on the head.

　　7. Take out the BNC interface, and then tighten it with a screwdriver.

　　8. Secure the bottom with pliers.

　　9. Scan the QR code on the manual with the mobile phone or download the APP software in the website of the manual. After installation, the installation of the webcam can be completed through the prompt operation of the software:

　　PS: If your webcam is equipped with the solar charging function, you can install the operation of the manual and connect the solar panel.

Read recommendations:

25X AI Tracking PTZ Camera

Introduction of Remote USB camera

HD web camera installation

ptz conference camera

SDI camera suppliers